Touchscreen & Pen Test
Touch, swipe and draw to check your touchscreen. This free touch test counts how many fingers your screen detects at once, maps dead zones across the whole panel, and shows pressure, contact size and stylus tilt where your device supports them.
How to use this test
- Place as many fingers on the test area as you can, and read "Max simultaneous".
- Swipe slowly across every cell of the grid until the whole grid turns green.
- Look for cells that never light up: those areas may not respond to touch.
- Draw lines, especially near the edges, and check that they follow your finger without breaks.
- If you have a stylus, draw with it to see pressure and tilt.
What this test checks
Multi-touch points
Shows the maximum touch points your hardware reports and how many fingers were actually detected at the same time in this test.
Dead zones
A grid covers the whole area. Cells light up as you touch them, so any part of the screen that never responds is easy to find.
Pressure and contact size
For each active touch, the pressure and contact size are shown on devices and browsers that report them.
Stylus pen
With a pen, the test shows its pressure and tilt, useful for checking a drawing tablet or a phone or tablet with a stylus.
Reading the results and fixing common problems
Part of the grid never turns green
Remove the screen protector and case, clean the screen and try again. If the same area still fails, the digitizer may be damaged.
Fewer touch points than expected
Many phones support 10 points, but some tablets, laptops and budget devices support fewer. A protector or a wet screen can also reduce detection.
Pressure always reads 0 or 1
Most phone and laptop screens do not report finger pressure to the browser. Pressure normally works with a supported stylus.
Touches appear by themselves (ghost touch)
Unplug the charger and try again, since cheap chargers can cause ghost touches. Clean the screen and remove a cracked protector. If it continues, the touch panel may be faulty.
Frequently asked questions
How do I test my touchscreen?
Open this page on the device, put several fingers on the test area to count touch points, then swipe across the whole grid until it turns green. Cells that never light up show dead zones.
How many touch points does my phone support?
The test shows the maximum your hardware reports. Most modern phones support 5 to 10 points.
How do I find dead zones on my screen?
Swipe across every cell of the grid. Any cell that stays unlit after several passes is an area that does not respond to touch.
Does it work with a stylus or Apple Pencil?
Yes. Pens are detected separately, and pressure and tilt are shown when the device and browser report them.
Can it test a touch laptop or a drawing tablet?
Yes. Touch laptops work like phones, and pen tablets show pen pressure and tilt when supported by the browser.
Related tests
Screen & Refresh Rate Test
Dead pixel & color test, gradient banding, real monitor refresh rate (Hz) and a moving-object motion test.
Open testSensor & Device Test
Accelerometer, gyroscope, compass, GPS, ambient light, battery, network, vibration and a browser API support matrix.
Open testMouse Test
Test all buttons, scroll wheel, double-click faults, click speed (CPS) and pointer movement.
Open test